Coolroom design and installation

Coolroom design and installation in Sydney.

New and replacement walk-in coolrooms for restaurants, clubs, hotels, food producers and facilities across Sydney and NSW, designed and installed by licensed refrigeration technicians and built to Australian Standards.

  • Designed for your load, not off a shelf
  • Built to Australian Standards and the NCC
  • Commissioned, tested and documented
1987In the refrigeration trade
0°C to 5°CTypical coolroom holding range
ARCLicensed refrigerant handling AU07173
HandoverCommissioning report and as-built details
Why design matters

Most coolroom problems start on the drawing board

An undersized system, the wrong panel or a badly placed door will cost you in power, breakdowns and lost stock for the life of the room.

Sized for real use

We size the refrigeration for how the room is actually used: how often the door opens, how much warm product goes in and how hot the plant area gets in summer.

Built for food safety

Smooth, cleanable surfaces, sealed joints, correct floor finishes and drainage, so the room stays easy to keep clean and pass inspection.

Efficient to run

The right insulation thickness, door seals, strip curtains and modern condensing units on lower-impact refrigerants keep power bills down.

Our process

From site measure to cold room

  1. Site visit and brief. We measure the space and talk through what you store, how much, and how the room will be used.
  2. Design and written quote. Room size, panel and floor, door type, shelving, refrigeration capacity and power requirements, all in one fixed quote.
  3. Approvals and coordination. We work with your builder, electrician and landlord, and advise on any approvals your project needs.
  4. Build and install. Panels, doors, refrigeration, pipework and controls installed by licensed technicians.
  5. Commission and hand over. Pull-down tested, temperatures verified and recorded, and a handover pack with warranty details.
What we build

Options for every site

  • Walk-in coolrooms for kitchens, cafés and bakeries
  • Keg rooms and cellar coolrooms
  • Bottle shop walk-in displays with glass doors
  • Produce, meat and dairy holding rooms
  • Combination coolroom and freezer room builds
  • Replacement refrigeration for existing rooms

Already have a coolroom that struggles? Often the panels are fine and only the refrigeration needs replacing. We will tell you which.

Walk-in coolroom condensing units installed by BM Refrigeration
After handover

Keep it running like new

Planned maintenance

A Certainty Plan keeps the new system clean, checked and documented from day one.

Planned maintenance →

Frigbot monitoring

A text the moment the room starts to warm, plus automatic temperature records.

How Frigbot works →

One point of contact

The team that built it services it, so nothing gets lost between installer and service contractor.

Questions

Common questions about new coolrooms

How much does a coolroom cost?

It depends on size, panel, door type, refrigeration and site access. After a site visit you get a fixed written quote with every item listed, so you can compare like for like.

How long does installation take?

Timing depends on the size of the room and panel and equipment lead times. We confirm the schedule in your written quote and plan the install around your trading.

Can you replace just the refrigeration?

Yes. If the panels, floor and door are sound, replacing the condensing unit and evaporator is often the most cost-effective fix.

Which refrigerant do you use?

We install lower-impact refrigerants such as R448A, R449A or natural options where suitable, in line with Australia’s HFC phase-down.

Planning a new coolroom?

Request a quote and we will arrange a site visit, or call 1300 669 353 to talk it through.